1.Material:Plastic,Nylon,Hdpe 2.Use:Grain Processing
3.Type:Deep/Low/No Bottom Bucket,Split/Rice Milling/Inductive Bucket
1.Deep Bottom Bucket
2.Low Profile Bucket
3.No Bottom Bucket
4.Split Bucket
5.Rice Milling Bucket 6.Inductive Bucket
Features:
1.High intensity, wear-resistance, corrosion-proof, with longer life span than
steel
buckets.
2.Light weight, extend the life span of the bucket, reduce the energy consuming
of
the elevators.
3.Good pliability , low product damage percent of only 1.
4.No spark caused in operation, avoid the possibility of dust exploration.
5.Clean discharge, wide temperature applications.ing cups 电梯油杯

Technical Index:
1.Method of Manufacture : Injection molded.
2.Drilling: Free of charge. Special drilling is offered according to customers
demand.
(For detailed drilling specifications, pls refer to the related specification chart)
3.Bucket Spacing : Minimum bucket spacing has historically been nominal
projection plus+50mm
4.Installation:Norway flat head elevator bolts, flanged bolt, sabre-tooth bolt,
and
belt bolt.
5.Sanitary Standard:in accordance with national sanitary standard.
Physical and Chemical Properties of HDPE
1.Density: 0.9350.960 g/cm2
2.Mechanical properties: Rupture strength: 900 N/cm2 Extensibility at break:
300%
3.Circumstance Temperature Range: -50+80 Heat-resisting Properties : Melting
Point:136
Vicat Softening Point: 134 Brittle Temperature :≤-70 Coefficient of Heat
Expansion
: 1.5×10-14m/ Thermal Deformation Temperature : 85
4.Friction Properties : Average rate of Friction : ≤1.32 Coefficient of Friction :
0.080.12
ESparks resulted form abnormal collision will not occur, nor does the electric
discharge because of strong static electricity electrostatic charge caused by
friction
in the operation.
Volume Resistivity : ≤7×1015Ω?cm