OXBOND mold release agent releases
epoxies (thermosets and prepregs),
polyester resins,and thermoplastic
compounds.

Appearance: Clear liquid
Solvents: Aliphatic Hydrocarbon
Odor: Hydrocarbon
Cured thermal stability: 400�C
(750�F)
Application Temp: 13�C - 60�C
(55�F
-140�F)
MoldPreparation
The mold surface must be clean and free
of any release agent or other
contaminants for OXBOND mold release
agent to be completely effective.
(Remove any contaminants with OXBOND
mold cleaner.For porous or repaired
molds, OXBOND sealer should be used.)
OXBOND mold release agent can be
applied to mold surfaces at room
temperature up to 60�C (140�F) by
spraying, brushing or wiping with a clean
lint-free, cloth.
1. Only a thin wet film is required. Wipe
or spray on a smooth, thin, continuous,
wet film.
2. Initially, apply two or more base coats,
allowing up to 5 -10 minutes after each
application for complete solvent
evaporation.
3. Aerosols may sometimes leave a
matte surface finish.To enhance gloss,
use a cotton cloth to gently buff up dry
film, if required.
4. Performance is enhanced by
recoating once, after the first few initial
pulls. Maximum releases will be obtained
as the mold surface becomes
conditioned to OXBOND mold release
agent.

OXBOND mold release agent is sensitive
to moisture , keep container tightly
closed when not in use,and should
always be used in well ventilated areas.
Store in a cool,dry place.
Shelf Life: One year from date of
manufacture

OXBOND mold release agent is available
in 1 gallon cans, 6 cans per case.